Have Any Questions?

01902 491 118

Operating Hours

Mon - Fri 07:30-17:00

Email Us

info@sterlingfiltration.co.uk

Worried About Water in Your Air Intake System?

The Filter Guys

Worried About Water in Your Air Intake System?

Sometimes you can’t help operating equipment in extreme moisture environments especially during the spring when the weather is unpredictable, but it’s good to be mindful of a few things to help keep your air intake system running at top efficiency.

Typical Symptoms of Water Ingestion:

  • High Restriction indications.
  • Mud caked in the VacValve
  • Wet, wavy air filter media
  • System rust, corrosion and/or water damage
  • Moisture-related environmental problems such as icing

Simple Tips to Keep Water Out of Your System:

  • Check and clear the VacValve daily
  • Make sure the air cleaner cover and filter are installed properly
  • Inspect air intake system for any leaks

Remember, a water-soaked air filter will occasionally lock-up a restriction indicator. Wet filters should always be replaced as they are prone to tear at weak, wet spots on the media. This would then allow the air flow to bypass the filter allowing dirt and debris into your air intake.

A restriction indicators ‘lock-up” restriction level is generally marked on the indicator itself. To check an indicator, remove it, wipe the base clean, then apply a small amount of vacuum. If the indicator locks up, it should still be okay to reuse this way. If not be sure to replace the indicator.

Donaldson Air cleaner assemblies and accessories are available to buy from Sterling Filtration Ltd.

Donaldson Filtration

Air filters: What is the purpose of a safety filter?

The Filter Guys

What is the purpose of a safety filter? Safety filter, secondary filter, inner filter; there are many names, we prefer to call it a safety filter.

A safety filter backs up the primary filter, and protects the clean air ducting while the primary is out of the housing during service. The engine should never be run with only a safety filter in place.

The safety filter is NOT a spare filter! Its purpose is to protect the engine if something goes wrong with the primary (main) filter. Until then, all it does is take up space and add a little bit of restriction.

What can go wrong with the primary filter?

It may have hidden damage from shipping that you missed when you inspected it before installation; damage from cleaning (if you carry out such an unrecommended procedure); maybe even a manufacturing glitch; mis-installation by the mechanic (but this never happens, right?); a ‘will-fit’ that doesn’t quite fit; or it’s the wrong part altogether and doesn’t fit at all into the housing (but mechanics would never try this, would they?)

All of these things happen more often than any of us like to think. We determined many years ago that a really good way to provide additional protection for large engines operating in heavy dust conditions was to always offer and for you to always use a safety filter.

There are some characteristics about the safety filter which you should be aware of, so you understand what it does and doesn’t do for your engine:

  • is smaller than the main filter, with less media.
  • is more open and less efficient for lower restriction.
  • has less contaminant-holding capacity so that it will plug rapidly if any engine-damaging dust particles get past a damaged primary filter.

A safety filter offers protection against mistakes when fitting and reduces the need to open the clean air side of the system by 66% (they usually only need changing once every three main filter changes) compared to systems without a safety filter. They are an excellent insurance against contaminants entering your engine and upon a critical failure of the main element can save your engine from serious damage.